The count of both Defects and Requitements should reflect the actual number of said Defects and Requirements. If a Test Run has hundreds of Test Cases and those Test Cases cover say a dozen Requirements the summary on the UI would state the Run covered thousands of Requirements. In addition it would create dozens and dozens of pages all listing those same 12 Requirements again and again. Feels like a waste of processing power. All of this would be the same would go for Defects.
Not sure a filter is the best way forward as this just hides the problem.
Welcome to the Testiny forum and thanks for your feedback!
I understand your point, especially about the numbering. The idea was to count all test cases a requirement or defect connected to.
There’s a very similar feature request here, still leaving it separate for now, just to connect these two requests:
If you reads this request and you would also like to have this feature, make sure to vote for this topic. We do consider the number of votes for feature requests in our roadmap and priority planning.
Best regards,
Alex